Technical parameter
Installation dimensions
Model description
Working Principle
Technical parameter
lever steam trap darwings
Spare parts and materials
No. Spare parts Materials No. Spare parts Materials 1 valve body WCB 11 support cap 304 2 Hexagon nut 35# 12 stem 304 3 hexagon bolt 35# 13 seal cover 304 4 PTFE PTFE 14 float ball 304 5 PTFE PTFE 15 hexagon bolt 304 6 support 304 16 Rotating block 304 7 bonnet WCB 17 Limit block 304 8 Meter screws 304 18 Connecting block 304 9 Seal seat 304 19 Spring washer 304 10 inner hexagon screw 304 20 hexagon nut 304
Installation dimensions
Model description
| Model | DESCRIPTION | |||||
| Valve type | CS41H | Free floating ball type | ||||
| CS11H | Free floating ball type | |||||
| JX58H | Lever float type | |||||
| JX88H | Inverted bucket | |||||
| Connection type | F | Flange type | ||||
| H1 | Butt welding type | |||||
| H | Plug in welding | |||||
| S | Internal screw thread | |||||
| Size | DN | DN15-DN500 | ||||
| pressure | PN | PN10-PN64 | ||||
| LB | 150LB-600LB | |||||
| K | 5K-40K | |||||
| material | WCB | WCB | ||||
| CF8 | Stainless steel | |||||
| Sample： CS41H-F-DN50-PN16-WCB Float type trap, flange connection, nominal diameter DN50, nominal pressure PN16, material WCB | ||||||
Working Principle
- Lever steam trapLever ball float type steam trap biggest advantage is not affected by pressure, temperature, condensation water flow fluctuations, continuous drainage, water line, the minimum temperature of 0 DEG C, can make the heating equipment to achieve the best efficiency; lever ball float type steam trap valve seat total in the level below, forming a water seal, no leakage of steam; the minimum working pressure 0.01Mpa, the maximum back pressure rate is less than or equal to 85%; with internal exhaust device, lever ball float type steam trap valve adopts the most advanced membrane components for automatic air discharge valve can automatically exclude non condensable gases, very sensitive, work quality is high, service life long. The trap design has balanced two seat structure, can achieve a large displacement of small size, especially for large heating equipment and heat transfer station equipment, gas drainage resistance, large heating equipment of choice for steam traps.
- The use of double valve valve hole, the valve core in the valve opening pressure is relatively reduced, resulting in large displacement. When the change of the float with the liquid level of the valve cavity on the floating lever to open or close the valve seat. Because the seat seal hole is formed below the water level, water, natural gas separation, to no leakage of steam.
Reviews
There are no reviews yet.